Leave Your Message
Carbonless paper 2-ply, 47 gsm, 713 × 864 mm, CB + CF
Loading...

Carbonless Paper 2-Ply — 47 gsm, 713 × 864 mm

2-ply 47 gsm carbonless paper on a 713 × 864 mm parent for seasonal invoice books for small retailers.

    Small retailers order invoice books in the hundreds rather than the hundreds of thousands, and a 713 × 864 mm parent at 47 gsm lets a local printer cut that short run economically. Two plies at this weight keep the finished book thin enough to post.

    Specifications

    Parameter Specification
    Plies / parts 2 parts per set
    Basis weight 47 gsm per ply
    Sheet size 713 × 864 mm
    Layer build CB + CF
    Copy colour sequence White top / Green CF
    Copy yield One copy on the CF ply
    Printing 1–2 colour flexo, numbering
    Finishing Edge glued, book form
    Parent form Flat sheets, guillotine trimmed

    How it runs

    Printing is done on the parent before collation, at 1 to 4 colours by flexo, and the 713 × 864 mm sheet leaves enough gripper for a forms press to run the job without trimming into the image area. The 2 plies are matched at 47 gsm so the set folds as one piece; edge gluing, pinning or fanfold conversion are all applied after printing, not before.

    Each ply can be tinted differently to mark its route, and the top sheet is kept white so the original reads as a clean document. On this 2-part specification the intermediate plies are the ones that usually carry a tint, while the final ply takes the darkest image. The tint is in the base paper, so it does not offset onto the ply above it in the stack.

    Where this specification stops

    Where the form will be filled in by a stylus on a tablet, this sheet is the wrong product: the copy depends on physical pressure across 2 plies. It also should not be used for adhesive-backed forms, because the ply thickness at 47 gsm gives a stiff set that will lift at the edge once glued to a backing.

    What to send for a quotation

    A quotation for this combination needs four things: the finished form size, the number of plies, the copy colour sequence, and the finishing method (edge glued, padded, pinned or fanfold). Add the print colours and any numbering pattern, and the parent size can be confirmed against your layout.

    • Finished part size and number of parts
    • Copy colour order across the plies
    • Print colours, numbering pattern and finishing
    • Parent size you can run on your press

    Leave Your Message