Leave Your Message
Carbonless paper 2-ply, 48 gsm, 610 × 860 mm, CB + CF
Loading...

Carbonless Paper 2-Ply — 48 gsm, 610 × 860 mm

2-ply 48 gsm carbonless paper on a 610 × 860 mm parent for small-format receipt books.

    At 48 gsm per ply on a 610 x 860 mm parent, this two-part sheet is the compact format for receipt books that are written in the hand and filed in a drawer. The parent is small enough that a converter can guillotine it into A5 or A6 parts with one cut sequence and very little trim.

    Specifications

    Parameter Specification
    Plies / parts 2 parts per set
    Basis weight 48 gsm per ply
    Sheet size 610 × 860 mm
    Layer build CB + CF
    Copy yield One copy on the CF ply
    Colour coding Single intermediate sheet, no colour coding needed
    Sheet form Flat sheets, cut to the parent size
    Printing 1–4 colour flexo, numbering and perforation on request
    Converting Edge glued, padded, pinned or fanfold

    How it runs

    On press, the 2-part collation runs as one set: 48 gsm CB on top, 48 gsm CFB in the middle where a third, fourth or fifth part is required, and 48 gsm CF underneath. The 610 × 860 mm parent is normally printed 1 to 4 colours by flexo, with numbering, perforation and edge gluing added in line. Because every ply in a set carries the same grammage, the collation feeds at one tension and the parts stay registered through the folder.

    The 2 plies are collated in a fixed order, white on top, tinted below, and the tint is what makes a five- or four-part set usable in practice. A clerk who has to route copies to stores, accounts and the customer can pull the right sheet without checking a legend. Intermediate plies can also be printed with a routing block if the form needs one.

    Where this specification stops

    Do not specify this combination for a set that has to survive a wet environment. Carbonless coatings are sensitive to moisture, and a 2-part form left on a damp loading dock will cockle before the image fades. For outdoor or chilled handling, a synthetic or thermal label route is the correct answer rather than a heavier carbonless sheet.

    What to send for a quotation

    To quote this sheet we need the finished part size and the number of parts, the copy colour order, and whether the set is glued, pinned or fanfolded. Tell us the print colours and whether numbering is required, and we can confirm the parent and the collation in one reply.

    • Finished part size and number of parts
    • Copy colour order across the plies
    • Print colours, numbering pattern and finishing
    • Parent size you can run on your press

    Leave Your Message