Leave Your Message
Carbonless paper 5-ply 55 gsm 787 x 1092 mm five collated plies
Loading...

Carbonless Paper 5-Ply — 55 gsm, 787 × 1092 mm

Five-ply carbonless sheet, 55 gsm per ply, 787 × 1092 mm, CB / three CFB / CF — for bills of lading and multi-signature documentation.

    A five-part set is not a bigger invoice, it is a different document: bill of lading, gate pass, weighbridge ticket, driver's copy, office file. Everything that moves with a truck needs a copy nothing else can replace, and the set has to survive being separated at a gate in the rain. This sheet is built as CB plus three CFB plies plus CF, at 55 gsm per ply in 787 × 1092 mm — the standard parent that most Asian and Middle Eastern form printers already run.

    Three middle plies, three chances to go faint

    In a five-part set the fourth ply is the one that fails first. Each CFB has to receive an image on its front and pass one to the back, so every additional middle ply adds a transfer step, and any weak coating shows up as a copy that is readable but grey. Buyers who test only the top and bottom copy of a five-part set approve batches that later come back from the field. Test ply four.

    Specifications

    Construction CB / CFB / CFB / CFB / CF
    Ply count 5 ply — 5-part sets
    Grammage 55 gsm per ply
    Sheet size 787 × 1092 mm
    Ply colours White top; white, yellow, pink, blue, green below — collated to your sequence
    Numbering Sequential numbering recommended across all five plies
    Binding Glued pads, wire-bound, fanfold continuous
    Pre-printing 1–4 colour flexographic, register-held across plies

    Applications

    • Logistics and freight documentation: consignment note, bill of lading set, delivery receipt, driver copy, control copy.
    • Weighbridge and quarry tickets where the loader, the driver, the gate and the office each keep a part.
    • Export packing and inspection packs that travel with a container.
    • Multi-signature approval forms in plants where four departments sign off one movement.

    Limits

    Five plies at 55 gsm make a set roughly as thick as a folded letter, and that thickness is what limits the machines it can run on. A dot-matrix printer with a narrow platen will feed four plies happily and jam on five; check the printer's maximum forms thickness before specifying. Handwriting through five plies needs a firm surface and a hard pen — a gel pen will produce a faint fifth copy.

    Above five plies the economics change: at six parts the set needs a heavier CFB and a specialised collator, and most buyers are better served by printing two four-part sets than one six-part set.

    Ordering

    Tell us the finished size, the collation order by colour, the numbering requirement and the printer the sets will run on. We will confirm the ply sequence and the caliper of the finished set against that printer before the run.

    Leave Your Message