Carbonless Paper 5-Ply — 80 gsm, 610 × 915 mm
When every copy of a document is a permanent record, thin paper is a false economy. This 610 × 915 mm five-part sheet runs at 80 gsm per ply, the heaviest construction in the carbonless range, and it is built for bound ledgers where the copies are read for years rather than days.
The stack is CB/3×CFB/CF. Four coating interfaces transfer the image down through the plies, and because each ply carries real substance, the pressure is distributed rather than absorbed — the fourth and fifth copies come out denser than they would in a light five-part build.
Specification
| Property | Value |
|---|---|
| Ply configuration | 5-ply, CB / 3×CFB / CF |
| Grammage | 80 gsm per ply |
| Sheet size | 610 × 915 mm |
| Sets per parent sheet | Six A4 sets |
| Ply colours | Top white; four lower plies in white, red, yellow, blue or green |
| Printing | 1–4 colour flexographic, heavy coverage |
| Finishing | Wire binding, hole punching, numbering, glued pads |
| Handling | Self-supporting; suited to bound, long-life ledgers |
Where it fits
Plant registers, laboratory logbooks and statutory inspection ledgers use this grade because the book is expected to stay in service and in readable condition long after the event it records. Wire binding works properly at 80 gsm, which is not true of the light grades, and the pages turn without the curl that develops in thinner stock after a few months of use.
Six A4 sets per parent keeps the yield reasonable for a heavy sheet, so even a small print run is practical for a single site. Numbering is applied across all five plies in one pass, so each copy in a ledger carries the same reference and can be traced back to the original entry without a separate index.
Selection limits
This is a specialist product and it is priced and weighted accordingly. A five-part book at 80 gsm per ply is thick and heavy — do not specify it for anything that has to be mailed or carried. It is not a continuous-feed stock, it will not run through a dot-matrix tractor, and it should not be used with laser overprinting because fuser heat pre-develops the coating.
What we need to quote
Send the binding method, the hole pattern, the numbering rule, the five ply colours and the finished page size. Quantity and delivery format complete the specification.
