Glassine Release Paper 40 gsm — Double-Side, White, 1,500 mm
A 1,500 mm roll of white 40 gsm glassine coated on both faces is the widest light double-coated liner here, and it exists for wide-web processes that need release in both directions without the caliper of a heavier base. Interleaving large sheets, laminating two adhesive webs, or running a wide web twice through a die-cutter — all three put the liner under pressure on both sides, and all three fail if one face bonds.
Both faces carry the same silicone specification. At 40 gsm the sheet is highly translucent and dense, so a wide web still runs light on the shaft and yields more metres per kilogram than any heavier base.
Specifications
| Grammage | 40 gsm |
| Silicone coating | Double side, matched faces |
| Colour | White (translucent) |
| Roll width | 1,500 mm |
| Maximum width | 1,650 mm available in this range |
| Roll length | 12,000–24,000 m |
| Resistance | High temperature, moisture, oil |
| Slitting | To customer requirement |
Where wide, light and double-coated all matter at once
- Wide-web double-sided adhesive production, where liner weight drives the cost of the finished roll.
- Interleaving large coated sheets stacked under load, where both faces must release.
- Two-pass converting where web orientation cannot be guaranteed on the second pass.
- Neutral applications under clear face stocks, where a tinted liner would show through.
At 1,500 mm the roll covers a full sheet-lamination table in one pass, which is the reason this width is specified rather than a narrower parent joined at the edge. A join in a release liner is a defect waiting to happen: the splice tape releases differently from the silicone, and the finished sheet shows it. A single unbroken web removes that risk entirely, and the light base keeps the roll inside the weight a standard shaft can carry.
Where it does not belong
A 40 gsm web at 1,500 mm is sensitive to tension variation — a plant without proper tension control will see edge wander that a 58 gsm roll would absorb. It is also the wrong base for heavy adhesive coats. And double coating on a job that only needs one release face is wasted spend; the single-side liner at this width does the same work for less.
What to send for a quotation
Tell us what contacts each face, the slit widths, the roll length, and whether a tension-control system is in place on the unwind. That last answer decides whether a 40 gsm parent this wide is the right specification or whether 58 gsm should be quoted instead.
