Leave Your Message
White glassine release paper 40 gsm single-side silicone 1400 mm thin roll
Loading...

Glassine Release Paper 40 gsm — Single-Side Silicone, White, 1,400 mm

40 gsm glassine release paper, single-side silicone, white, 1,400 mm — thin liner in long rolls for high-volume label work.

    Forty gram glassine at 1,400 mm is the liner you buy by the metre when the job is long and the liner is thrown away. At this weight a 24,000 m roll carries roughly the same square metres as a heavier sheet in a much shorter length, which means fewer reels per shift, fewer splices, and less freight per square metre delivered. This roll is 40 gsm, single-side silicone, white, 1,400 mm.

    The economics of thin liner at long length

    Liner cost per label has three parts: the price per square metre, the waste at the end of each reel, and the labour of changing reels. Thinning the sheet attacks the first directly and the other two indirectly, because a lighter roll at the same diameter holds far more metres. On a labelling line that is the difference between changing a reel once a shift and twice.

    The limit is mechanical. Below about 40 gsm a glassine liner becomes difficult to coat evenly and hard to die-cut without scoring, which is why this is the light end of the range rather than the start of a continuum.

    Specifications

    Grammage 40 gsm
    Silicone coating Single side
    Colour White
    Roll width 1,400 mm — slit to your finished width
    Roll length 12,000–24,000 m
    Base sheet Translucent super-calendered glassine, smooth waxy surface
    Resistance High-temperature, moisture and oil resistant
    Application Label release liner, adhesive protection, food packaging interleaving

    Applications

    • High-volume label stock where liner cost dominates the bill of materials.
    • Barcode and logistics labels produced on long, uninterrupted runs.
    • Food packaging interleaving where a thin, clean release sheet is enough.
    • General industrial protection between finished surfaces during transport.

    Where thin liner will trip you up

    Thin liner exposes every other weakness in the process. A worn die will cut through 40 gsm where it merely marked a 58 gsm sheet. An uneven laminating nip will wrinkle it. A badly tensioned unwind will make it flutter at the infeed and print out of register.

    If you are moving down from 50 gsm to save cost, run a trial reel before committing to a container. If the die is at the end of its life, the saving on liner will be wiped out by web breaks within a week.

    This is also not a liner for very large label formats. On a large die-cut shape the thin sheet has too little body to bridge the cut and strip cleanly, and the labels will lift at the edges as the web leaves the die station.

    Ordering

    Send the finished widths, the roll length you want, the die type and the line speed. If you are currently running a heavier liner, tell us what it is — we will advise whether 40 gsm is a safe step down for your die and your tension control.

    Leave Your Message