Leave Your Message
Yellow glassine release paper 58 gsm single-side silicone 1300 mm heavy roll
Loading...

Glassine Release Paper 58 gsm — Single-Side Silicone, Yellow, 1,300 mm

58 gsm glassine release paper, single-side silicone, yellow, 1,300 mm — heavy liner for foam, rubber and hand-stripped adhesive parts.

    Foam, rubber and gasket converting is harder on a liner than label work, because the adhesive is often aggressive, the liner is stripped by hand, and the finished part may sit in a warehouse for months before it is used. A 58 gsm single-side glassine in yellow at 1,300 mm is built for that duty: heavy enough that a hand strip does not tear it, coated on one face so the other face grips the material it is protecting, and coloured so it is never confused with the part itself.

    What single-side coating does in a converting line

    The uncoated face is not a defect, it is the working face. On a foam or rubber web the liner's job is to protect the adhesive until assembly; the uncoated side sits against the material and holds position, while the silicone side releases when the part is applied. A double-coated liner would slide in the stack and make the parts hard to separate and count.

    Specifications

    Grammage 58 gsm
    Silicone coating Single side
    Colour Yellow
    Roll width 1,300 mm — slit to your finished width
    Roll length 12,000–24,000 m
    Base sheet Dense super-calendered glassine, high internal strength
    Resistance High-temperature, moisture and oil resistant
    Typical use Foam and rubber interleaving, adhesive protection, die-cut part liner

    Where this specification is used

    • Protective liner for double-sided foam tape before it is cut into gaskets.
    • Interleaving between rubber sheets that would otherwise cure against each other in storage.
    • Release face for construction and insulation adhesive products.
    • Die-cut part carrier where the liner stays with the part until the fitter peels it.

    Selection notes

    Yellow is not decoration here. In a plant that also handles white liner for label stock, a coloured liner makes it obvious at a glance that a roll belongs to the foam line and not to the label press, which prevents a changeover error that would otherwise only show up as a release failure downstream.

    Fifty-eight gsm is chosen for strength, and strength costs money. If the liner is machine-stripped on a high-speed line rather than handled, a 50 gsm sheet may be adequate and cheaper. Where it is hand-stripped from a large part, or where the part is stored flat under load, the heavier sheet is what stops the liner from cockling and lifting at the edge.

    This is a single-side product. For a process that needs release from both faces — a double-coated tape, or a stack where the liner sits between two adhesive surfaces — order the double-side construction instead.

    Ordering

    Send the finished slit widths, the material the liner will protect, the adhesive type and how the liner is removed (by hand or on a machine). We will confirm the slit plan on the 1,300 mm parent and advise on the grammage for the way the liner is actually handled.

    Leave Your Message