Leave Your Message
Thermal paper jumbo roll 790 mm, 55 gsm, 18,000 m, 3 inch core
Loading...

Thermal Paper Jumbo Roll 790 mm — 55 gsm, 18,000 m

Thermal jumbo roll 790 mm, 55 gsm, 18,000 m, 3 inch core, for mid-weight wide web for multi-lane slitting.

    Seven hundred and ninety millimetres, 55 gsm, 18,000 m: the middle of our thermal range on a wide web. Converters pick it when a 48 gsm sheet feels too flimsy in the finished roll but a 70 gsm web would over-spec the receipt, and the 18,000 m reel keeps slitter changeovers down.

    Specifications

    Parameter Specification
    Grammage 55 gsm
    Roll width 790 mm
    Roll length 18,000 m
    Core 3" (76 mm), custom on request
    Coating Top-coated direct thermal, BPA/BPS free
    Image life 5–10 years
    Slitting plan Multi-lane slitting to POS and mid-web widths
    Converting fit mid-weight wide web for multi-lane slitting
    Shelf life 2 years in cool, dry storage

    How it runs

    Coating weight and base weight are matched: a 55 gsm base carries enough coating to image densely without the speckle that appears when a light base is over-coated. The sheet is BPA and BPS free, prints without ribbon or ink, and gives a five to ten year image life when it is stored away from heat and direct light.

    Slitting a 790 mm parent at 18,000 m is the step that decides the yield: the lanes are set to the customer's finished widths, and the remainder is planned rather than left over. Cores are 3 inch as standard, custom on request. Pre-print of up to eight colours happens before slitting so register is set once for all lanes.

    The reel is delivered wrapped with the grade, width, length and core marked on the label. Thermal paper is sensitive to heat and light even before it is printed, so the wrapper should stay on until the reel is on the machine. Two years is the working shelf life under cool, dry storage.

    Where this specification stops

    A 55 gsm thermal sheet is the wrong choice for a application that needs an opaque, write-on surface: ballpoint and stamp ink do not bond well to the coating. If the document has to be signed or stamped, a carbonless form or a woodfree label is the better route.

    What to send for a quotation

    Send the finished widths, the core, the roll length you can handle on the slitter and any pre-print requirement. With the printer model and the storage conditions the rolls will see, the grade and coating can be confirmed rather than guessed.

    • Finished slit widths and the slitting plan
    • Core size your unwinder takes
    • Printer family and energy setting
    • Pre-print colours, if any

    Leave Your Message